Configuration for installer
To enter configuration parameter it is necessary to stop the controller.
Press
Press for 5". Green display shows 0000 with 1st digit fl ashing, red
1
CYCLE
display visualizes pass .
Flashing digit on green
2
display changes.
STEP
On green display appears the first
3
parameter while red dislay shows
STEP
the value.
Allows to switch from mnemonic
(parameter name) to numeric
4
CYCLE
(parameter number) visualization
(and vice versa).
5
Scrolls parameters.
Allows to modify parameter: red
6
display visualizes (flashing) the
STEP
value of the selected parameter.
Increases or decreases the
7
visualized value.
Confirms data entering (red
8
STEP
display stops flashing).
Configuration ends.
9
START
STOP
The controller is in stop .
Entering password 1234 it is possible to modify the first level parameters.
If it is necessary to modify those of second level, enter password 5678 .
Display
Enter the password 1234 .
Select the parameter to be
modified.
Enter the new data.
To modify another parameter
back to point 5.
User manual - ATR902 - 19
Do