Technical Data; Wire Diagram - Beninca CP.J4 ESA Manual De Instalación

TECHNiCAL dATA

Contol unit power supply
Power supply
Output
Motor maximum power
Accessories power supply
Protection level
Operating temp.
Radio receiver
Memory capacity
Wire connections shown in Fig. 1 are described hereunder:
Terminals Function
L/N Power supply
Primary
L1/N1
Transformer
0V/MOT/ Secondary
AUX Transformer
M1 Motor
SAFETY
BAR/BAR
EDGE
CLOSE CLOSE
OPEN OPEN
PHOT Photocell
STOP STOP
P.P. Step by step
+COM COMMON
SHIELD/ANT antenna
+ 24V - 24 Vac/dcs
BLINK Flashing
SCA AUX1
24 Vdc
230 Vac 50/60 Hz or 115Vac 50/60Hz according to the version
1 motor 24Vdc
220 W
24Vdc 1A max.
IP40
-20°C / +70°C
built in 433,92 MHz confgurabile (rolling-code or programmable + rolling-code)
64 rolling-code transmitters
CoNTRoL PANEL CP.J4 ESA

WiRE diAGRAm

description
Input, 230VAC 50/60 Hz (L-Phase/N-Neutral)
Connector for the connection of the primary transformer
L1: Line
N1: Neutral
Connector for the connection of the secondary transformer
0V: Input, 0V – MOT: 30 VAC - AUX: 18 VAC
Fast connector for the connection of the motor equipped with Encoder
Input, safety edge. A 8.2 Kohm resistance is pre-installed on the terminals.
Safety edge of the resistive type, 8K2: connect the edge to the terminals by eliminat-
ing the pre-installed resistance, as shown in Figure 3.
Safety edge of the mechanical type: connect the edge in series to the resistance, as
shown in Figure 3.
When the safety edge is activated, the door movement is stopped and reversed for
around 3sec.
Input, CLOSE push-button (Normally Open contact).
Input, OPEN push-button (Normally Open contact).
A timer/clock can be connected for openings according to timeframes.
Input, photocell is activated in the closing phase.
STOP button input (N.C. contact)
STEP BY STEP input ( N.O. contact)
Common for all control inputs.
Connection antenna to the built-in receiver
SHIELD: Screen / ANT: Signal
Accessories power supply 24Vac/1A max.
Warning: With the backup battery card CB.24V, the output (without mains) is 24Vdc
(polarized).
Check devices connection polarity.
Connection to flashing light 24Vdc 15W max.
Normally open (N.O.), clean contact, which is configurable like SCA (open gate in-
dicator light) through parameter AUX1, second radio channel, courtesy or area light
(see Parameter AUX 1).
13