DXV AT200 LS SpaLet Manual De Instalación página 10

DECIDE THE INSTALLATION
C-3
POSITION OF SECURING MEMBER
1
Place the paper template in line with the base of
the water drain socket and secure it with colored
tape. Mark screw position of securing member.
2
Cut off the paper template along the right and left
dotted line and secure the securing member.
* For tile or concrete floors, drill a smaller hole and
use an anchor.
Note: If there is a gap or looseness, bond the drain
socket with caulking.
3
Place the mounting adhesive on top of the
mounting base with contoured surface facing down.
• Ensure that the mounting adhesive is placed in
the center of the plate.
• Prevent moisture or impurities from getting on the
mounting base.
4
Take out the supplied installation support base
5
Lift up the front edge of the SpaLet
insert the installation support base under the
ceramic bowl.
Note: Do not put the ceramic bowl all the way down
to the floor. Failure to do so may crush the
water supply hose.
6
Place the ceramic bowl onto the installation support
base.
® bowl and
- 10 - 7302348-100 (11/17)