DXV AT200 LS SpaLet Manual De Instalación página 12

C-4
INSTALLING THE SpaLet
1
Set wall protection cover against the wall.
Move the SpaLet bowl with installation support
2
base to just before the drain socket.
Attach colored tape vertically from the screw hole
3
on the lower side of the SpaLet bowl.
4
Insert your hand in the space of the installation
support base and lift up the SpaLet bowl.
Adjust the tape position on ceramic bowl to the
▲ mark position on the floor.
Set the drain socket on the drain outlet
Lower the SpaLet bowl. Make sure that the
5
position of the ▲ mark on the template paper on
the floor coincides with the position of the tape on
the ceramic bowl.
Insert the screw into the SpaLet bowl side, secure
6
the securing member and SpaLet bowl, and then
attach the screw cap. Remove the wall protection
cover.
Push the front edge of the ceramic bowl
7
downward.
No.2
②
7
BOWL
®
- 12 -
①
7302348-100 (11/17)