Evolution RAGE 5 Instrucciones Originales página 26

Ocultar thumbs Ver también para RAGE 5:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 70
ASSEMBLY & OPERATION
FIG. 38
FIG. 39
FIG. 40
Note: Although the Mitre Gauge can be locked in any desired
position along the 'T' slot it does have a dedicated position to
the front of the carriage, where the locking screw will engage in
a hole in the sliding carriage body. (Fig. 38)
Install the Hold Down Clamp, if required, onto the pillar fitted
into the Mitre Gauges main body. (Fig. 39) Tighten in the
required position using the locking screw.
Place the workpiece in the required position and against the
Mitre Gauge Face Plate.
Clamp the workpiece to the Sliding Carriage by adjusting the
Hold Down Clamp for best position and tightening the vertical
locking screw using the large knob. (Fig. 40)
The Mitre Gauge has its own locking screw to lock it to the
sliding carriage, but when used with the Hold Down Clamp,
additional security is obtained. Check the integrity of the
installation.
Note: We recommend that the above set up procedure is
completed with the Sliding Carriage pulled out from the
machine table to give the operator the clearance and space to
make any measurements, confirm cutting lines etc.
When satisfied that all adjustments and cutting line positionings
etc are correct, and all adjustment screws are securely
tightened, open the On/Off switch cover plate.
Start the machine and push the Sliding Carriage (by using the
Mitre Gauge) to the rear of the Table to make the cut.
26
www.evolutionpowertools.com

Publicidad

Tabla de contenido
loading

Tabla de contenido