Safety Precautions For All Saws; Additional Specific Safety Rules - Evolution RAGE 5 Instrucciones Originales

SAFETY PRECAUTIONS FOR TABLE SAWS
a) Do not use saw blades which are
damaged or deformed.
b) Replace the table insert/access plate if
worn.
c) Use only blades as recommended in this
manual, which conform to EN 847-1. When
changing a saw blade ensure that the width of the
groove (kerf) cut by the blade is slightly greater
than the thickness of the riving knife. Also the
thickness of the blade body must not be greater
than the thickness of the riving knife.
d) Take care that the selection of the saw
blade is suitable for the material to be cut.
e) Wear suitable personal protective
equipment when necessary. This could include:
Hearing protection to reduce the risk of
induced hearing loss.
Respiratory protection to reduce the risk of
inhalation of harmful dust.
Wearing gloves when handling saw blades or
rough material.
f) Saw blades should be carried in a holder
whenever practicable.
g) Never perform any operation freehand.
This means using only your hands to
support or guide the workpiece. Always use
either the fence or mitre gauge to position and
guide the work.
WARNING:
Freehand cutting is a major
cause of accidents.
h) Never attempt to free a stalled blade
without first turning the saw off. Turn the
power off immediately to prevent damage
to the motor.
i) Provide adequate support for long or
wide workpieces.
j) Avoid awkward operations and hand
positions where a slip could cause your
hand to move into the blade.
k) Do not operate the appliance with a
damaged cord or plug. If the supply cord
is damaged, it must be replaced by the
www.evolutionpowertools.com
manufacturer or its service agent or
a similarly qualified person in order
to avoid a hazard.
ADDITIONAL SPECIFIC SAFETY
RULES FOR TABLE SAWS
WARNING:
Before using your table saw it is
important that you read and understand these
safety rules. Failure to follow these rules could result
in serious injury to the operator or damage to the
table saw.
a) Always use the blade guard. The blade
guard must always be used in every operation.
b) Hold the work firmly. Against the mitre
gauge or rip fence.
c) Always use a push stick. Especially when
rip cutting narrow stock.
d) Keep guards in place and in working
order. Always ensure that the riving knife is
fitted and correctly adjusted. Inspect the riving
knife regularly and replace it if it is worn. Use
only a genuine Evolution riving knife as this is a
dedicated component for this machine.
e) Remove adjusting keys and wrenches.
Form the habit of checking to see that keys
and adjusting wrenches are removed from the
machine before turning it on.
f) Do not use in dangerous environment.
Do not use power tools in damp or wet
locations, or expose them to rain. Keep work
area well lit. Keep the area well ventilated.
g) Keep children away. All children and
visitors should be kept at a safe distance from
the work area.
h) Do not use High Speed Steel (HSS)
blades. Ensure that the correct blade is selected
for the material being cut.
i) The push stick or push block should
always be stored with the machine when
not in use.
j) Connect the saw to a dust collection
device when sawing wood. The operator
should be informed of the factors that influence
exposure to dust e.g. type of material being cut
8