Troubleshooting - Honda WX10T Manual De Explicaciones

36YH46000.book 38 ページ ２０１４年８月２８日 木曜日 午前１１時７分

11. TROUBLESHOOTING

When it is hard to start the engine:
In some cases, restarting of the engine may become difficult sometime
after stopping the engine because the mixture in the combustion
chamber becomes excessively rich. In such a case, carry out the
following procedures 1–4 to expel the rich mixture.
1.Turn the engine switch to the OFF position.
2.Move the choke lever to the OPEN position.
3.Keep the throttle lever to the FAST position.
4.Pull the starter grip 3–5 times.
CAUTION:
Be sure to turn the engine switch to the OFF position.
If this operation is executed with the engine switch at the ON position,
the equipment may start to move when the engine starts, and a
personal injury may result.
Start the engine referring to the procedures described in STARTING
THE ENGINE.
• Start the engine with the choke lever in the OPEN position.
When the engine will not start:
1.Is the engine switch in the ON position?
2.Is there fuel in the fuel tank?
3.Is gasoline reaching the carburetor?
To check, press the priming pump several times.
4.Is the spark plug in good condition? (see page 31)
Remove and inspect the spark plug. Clean, readjust gap and dry the
spark plug. Replace it if necessary.
5.If the engine still does not start, take the pump to your servicing
dealer.
38