BMR THE FLEX BELT Manual De Usario página 14

QUICK GUIDE TO SOLVING PROBLEMS
Problem
Display doesn't come
on / no signal from
the controller
The display is on but
there is no signal.
The battery symbol is
flashing
The symbol has
appeared on the
display* and/ or the
controller is beeping
Unpleasant feeling
beneath the gel pads
The contractions are
very weak even when
the toning intensity is
high
"Err" appears on the
display
* The symbol always appears in conjunction with the left/right intensity indicators. If the left indicator appears,
there is a problem with the left GelPad, the right indicator acknowledges a problem with the right GelPad and
if both indicators appear there is a problem with either the middle GelPad or all three GelPads.
14
Possible Cause
The battery is low
The battery is low
Controller not properly connected to
the belt
The GelPads are on the wrong way
around
The covers are still on the GelPads
The GelPads are worn
The GelPads are not covering the
studs
Build up of gel on the metal studs
Poor GelPad contact with the skin
The GelPads are worn
Build up of gel on the metal studs
The GelPads are not covering the
studs
Too many consecutive sessions
The GelPad s are worn
The battery is low
Poor GelPad positioning
GelPads are not covering the metal
studs
Error message
Solution
Recharge the battery
Recharge the battery
Ensure the controller and belt are properly
connected
Ensure the black surface of the GelPads
are facing you
Remove the covers from the GelPads
Visit www.theflexbelt.com or contact
Customer Care for replacement GelPads
Make sure the GelPads fully cover the
metal studs
Clean the metal studs with a clean, dry cloth
Press the GelPads firmly against the skin.
Smear a few drops of water on the surface
of the GelPads. Make sure the controller is
OFF first
Visit www.theflexbelt.com or contact
Customer Care for replacement GelPads
Clean the metal studs with a clean, dry cloth
Reposition the GelPad s so the metal studs
are covered
You should just do one session per day on
any single body area
Visit www.theflexbelt.com or contact
Customer Care for replacement GelPads
Recharge the battery
See pages 7 & 8 for correct gel pad
positioning
Reposition the GelPad s so the metal studs
are covered.
Switch the controller off and on. It should
work without any problem. If the error
message persists call CustomerCare for
advice.