BMR THE FLEX BELT Manual De Usario página 5

INTRODUCING THE FLEX BELT BY BMR
You should find the following parts inside your pack.
2
1
3
6
5
4
7
1. Belt:
Your belt has been ergonomically designed and is fastened around your waist, under your clothes, during use.
Designed for both men & women, it fits waist sizes 24"- 47". The belt has a pocket for holding your controller
during use.
2. Controller:
The controller generates signals which are sent, via the belt and GelPads, to your muscles to make them contract.
Your controller is rechargeable and takes approximately 3 hours to charge fully.
3. Controller Connector:
This connects the controller to the toning belt. Make sure the controller is fully connected to the belt.
: Do not disconnect the controller from the toning belt until it has been switched off.
IMPORTANT
4. Pack of three adhesive GelPads:
These adhesive GelPads are placed onto your belt before use. When you wrap the belt around your waist,
these GelPads must be in contact with your skin so the signals can be sent to your muscles.
5. Battery Charger:
THE FLEX BELT
Plug the charger into an electrical outlet and then connect your controller to the charger to charge the battery.
Please ensure you only use the charger supplied by .
THE FLEX BELT
6. Instruction Manual:
This is a detailed guide to using your by BMR.
THE FLEX BELT
7. Quick Start Guide:
This is an additional quick start guide that you can use to help you get started.
5