Burner Cleaning; Serial Number Plate - Beretta Ciao Green 25 R.S.I. Manual De Instalacion Y Uso

CIAO GREEN R.S.I.
Do not clean the appliance or any latter part with flammable substances
(e.g. petrol, alcohol, etc.).
Do not clean panelling, enamelled and plastic parts with paint solvents.
Panels must be cleaned with ordinary soap and water only.
MAINTENANCE FOR PRESSURISED COLLECTIVE CHIMNEY
(3CEp)
In the event of maintenance operations on the boiler which require the flue
gas pipes to be disconnected, a cap should be placed on the open element
originating from the pressurised smoke pipe.
Failure to adhere to the guidelines provided can compromise the security
of persons and animals due to potential leakages of carbon monoxide from
the smoke pipe.

BURNER CLEANING

The flame side of the burner is made with an innovative material of the
latest generation.
- Be especially careful during the dismantling, handling and installation of
the burner and the components next to it (e.g.. electrodes, insulation pa-
nels, etc.)
- Avoid direct contact with any cleaning device (e.g. brushes, vacuum cle-
aners, blowers, etc.).
In general, the burner does not require maintenance, but particular cases
may occur where cleaning is necessary (e.g.. distribution network of gas
containing solid particles and in the absence of a filter on the line, suction
air containing excessively adhesive particulates, etc.).
For this reason, perform a visual control of the burner in order to ensure the
proper functioning of the product:
- Remove the front cover of the air box
- Unscrew the fastening nut of the gas train to the valve, remove the gas
train spring clip to the mixer and turn the gas train outwards
- Remove the silencer from the mixer
- Disconnect the connectors of the wiring from the fan and the connecting
cables of the electrodes
- Unscrew the fixing screws and remove the exchanger-fan cover assem-
bly from its seat
- Unscrew the fixing screws and remove the burner from its seat checking
it condition
If necessary, clean the burner with compressed air, blowing
from the metal side of the burner
It is possible that with ageing, the fibres constituting the flame
side of the burner can tone the colour
- Reassemble everything in reverse order
If necessary, proceed with the replacement of the sealing gas-
kets
The manufacturer declines all responsibility for any damage caused from
the failure to observe that stated above.
12

6 SERIAL NUMBER PLATE

Heating function
Qn
Nominal heat delivery
Pn Nominal heat output
Qm
Reduced heat delivery
Pm Reduced heat output
IP
Degree of Protection
Pms Maximum heating pressure
T
Temperature
D
Specific flow rate
NOx NOx class
3CEp The boiler may be connected to a system operating under pressure
(3CEp) by means of a check valve/non-return valve.
Via Risorgimento 13 - 23900 Lecco (LC) Italy
Caldaia a condensazione
IT:
Condensing boiler
ES-PT-SI-TR-HR:
Caldera de condensación
SK-CZ-LT-GR-HU:
Centrala in condensatie
RO-AT:
Chaudiere a condensation
Brennwertkessel DK-EE-LV:
Kocioł kondensacyjny
PL:
Serial N.
NOx:
230 V ~ 50 Hz
IP
Pms = T=
0694/00
80-60 °C 80-60 °C 50-30 °C
Qm =
Qn =
Pn =
Pm = Pn =
regolata per:
set at:
calibrado:
reglat:
réglage:
engestellt auf:
η
dostosowane do: