ELICA Ecolution Platinum-Ola-Wave Guía De Instalación, Uso Y Mantenimiento página 11

12. Insert the cover between the support cables, making
sure they enter the special slots on the cover.
Important! Leave enough cable so that it passes easily
through the slot obtained in the cover.
Secure the cover with 3 grub screws already screwed on
the support bracket.
Note: The 3 fixing screws secure the cover by virtue of
the friction they exert on the cover itself, and therefore
must not be completely tightened.
13. Check all light bulbs to make sure they are secure in
their sockets.
Turn power (On) in service panel.
Check lights and blower operation.
14. Install filter.
Installation wall model
1. If possible, disconnect and move freestanding or slide-in
range from cabinet opening to provide easier access to
rear wall. Otherwise put a thick, protective covering over
countertop, cooktop or range to protect from damage
and debris. Select a flat surface for assembling the unit.
Cover that surface with a protective covering and place
all canopy hood parts and hardware in it.
2. Determine and mark the centerline on the wall where the
canopy hood will be installed.
3. Select a mounting height comfortable for the user and
mark on wall.
4. Tape template, matching center-line and hood bottom as
shown in Figure below.
5. Mark center of four fastener location then remove
template.
6. Mark wall with horizontal line 1" above highest and 1"
below lowest fastener location.
7. Find studs behind drywall by tapping wall or using a stud
finder. Mark the center of the studs with a vertical line to
the right and left of the marked fastener location.
11