ELICA Ecolution Platinum-Ola-Wave Guía De Instalación, Uso Y Mantenimiento página 13

16. Remove the junction box and apply the wall model
junction box (supplied in mounting hardware kit).
17. Electrical connection
WARNING
Electrical Shock Hazard
Warning: Turn off power circuit at the service panel
before wiring this unit.
120 VAC, 15 or 20 Amp circuit required.
ELECTRICAL GROUNDING INSTRUCTIONS
THIS APPLIANCE IS FITTED WITH AN ELECTRICAL
JUNCTION BOX WITH 3 WIRES, ONE OF WHICH
(GREEN/YELLOW) SERVES TO GROUND THE
APPLIANCE. TO PROTECT YOU AGAINST
ELECTRIC SHOCK, THE GREEN AND YELLOW WIRE
MUST BE CONNECTED TO THE GROUNDING WIRE
IN YOUR HOME ELECTRICAL SYSTEM, AND IT
MUST UNDER NO CIRCUMSTANCES BE CUT OR
REMOVED.
Failure to do so can result in death or electrical
shock.
Install the conduit connector (cULus listed) in junction
box.
Connect black wire from service panel to black or red in
junction box, white to white and green to green-yellow.
18. • Mark 2 screw hole locations in the wall.
• Drill 5/16" pilot holes in the marked locations.
• Install wall fastener anchors.
• Drive wood screws, by hand, into the fastener to allow
anchors to expand. Remove the screws.
• Secure the junction box to the wall with wood screws
and/or fasteners.
19. Close and secure junction box cover.
Install the charcoal filter on the back side of the grease filter,
install both on the range hood and turn power on at service
panel. Check operation of the hood.
If range hood does not operate:
• Check that the circuit breaker is not tripped or the house
fuse blown.
• Disconnect power supply. Check that wiring is correct.
To get the most efficient use from your new range hood,
read the "Use and Care Information" section.
Keep your Installation Instructions and Use and Care
Guide close to range hood for easy reference.
13