Temperature Regulation - Sime OPEN.zip 25 BF TS Instrucciones Para El Instalador

TEMPERATURE REGULATION

According to programming and the environ-
ment temperature detected, the remote
control will generate the request for hea-
ting and will activate the output relay by
hysteresis (fig. 7).
CONTROLS (fig. 8)
Programming and use of the device are
explained in a standard manner and graphi-
cally with certain simple commonly used
symbols.
In programming and configuration, only
what is significant for the operation in que-
stion is displayed, and what is being modi-
fied flashes on and off ("blink" effect).
LANGUAGE/DATE/TIME SETTING
The key [CONFIG.] gives access to the
"CONFIGURATION" of the remote control,
where it is possible to:
- select the day display mode: Italian or
English
- set the current day of the week
- set the current hour
- set the current minutes
- select the time display
0-24/AM-PM
- total resetting of the device or the manu-
facturer's setting
The flashing part of the display is in grey
LANGUAGE
[ + ] and [ - ]: to select Italian or English
[OK]: proceed with setting the day
[CONFIG.]: exit configuration
ON
mode:
SAN
DAY
[ + ] and [ - ]: to set the day
[OK]: allows to proceed with setting the
time
[CONFIG.]: exit configuration mode
TSet
Turn ON Turn OFF
∆Turn ON ∆Turn OFF
0.5°C 0.5°C
PROG.
Incolla
Plant filling
Copia
RIEMP.
Heating setting
RISC
Sanitary water setting
[ + ] and [ - ]: to set the hour
[OK]: allows to proceed with setting the
minutes
[CONFIG.]: exit configuration mode
T
OFF
Fig. 7
Change of functioning
M
mode
+
Increase
ok
Confirmation
–
Decrease
S
Next page
Configuration
CONF.
Reset
Reset
Programming
Paste
Copy
Fig. 8
TIME
71