PR 9113 Manual De Instalación página 30

LERBAKKEN 10, 8410 RØNDE DENMARK
Ex input
CH1 (terminal 41,42,43,44)
CH2 (terminal 51,52,53,54)
U : 8.7 V
o
I : 18.4 mA
o
P : 40 mW
o
Lo/Ro 892 μH/
IIC
C
5 F
o.
L 100 mH
o.
U : 10 V
i
I : 30 mA
i
C : 30 nF
i
L 820 nH
i.
Status Relay. terminal (33,34)
Voltage max.:
Power max.:
Current max.:
Zone 2 installation:
Voltage max.:
Power max.:
Current max.:
Installation notes:
For installation in Zone 2, the module must be installed in an outer enclosure having an IP protection
of at least IP54 conforming to the requirements of IEC60079-15.
For installation on Power Rail in Zone 2, only Power Rail type 9400 supplied by Power Control Unit
type 9410 is allowed.
In type of protection "intrinsic safety iD" the parameters for intrinsic safety for gas group IIB are
applicable.
After the sensor circuits (Terminals 41..44, 51..54) have been installed in a type of protection, other
than "intrinsic safety" the module shall not be re-installed in type of protection "intrinsic safety"
Do not separate connectors when energized and an explosive gas mixture is present.
Do not mount or remove modules from the Power Rail when an explosive gas mixture is present.
Revision date:
2009-11-27
28
IIB IIA
50 F 1000 F
300 mH 700 mH
Version Revision:
V3 R0
9113 - Product Version 9113-003
125 VAC / 110 VDC
62.5 VA / 32 W
0.5 A AC / 0.3 ADC
32 VAC / 32 VDC
16 VA / 32 W
0.5 A AC / 1 ADC
Prepared by:
PB
9113QI01
Page:
2/3