If No Password Is Set - PR 9113 Manual De Instalación

Safety Manual

14.2.1 If no password is set

1
2
3
4
5
6
7
8
9
10
11
12
13
14
14
9113 TeMpeRaTuRe / ma CONVeRTeR
action
press OK
Set (aDV.SeT) to Yes and press OK
Set SeTup to SIL and press OK
Set eN.SIL to YeS and press OK
Set password to a number between 0 and
9999 and press OK
(at this time the device starts operating
in SIL mode with the entered configuration
parameters!)
press OK to confirm verification of the OpeN-
>LOCK in the display
Verify input type for Channel 1 and press OK
Verify fixed input range and press OK
(ONLY IF CH1.TYp = CuRR)
Verify sensor connection type and press OK
(ONLY IF SeNSOR = Ni or pt and CH1.TYp =
TeMp)
Verify temperature unit and press OK
(ONLY IF CH1.TYp = TeMp)
Verify temperature sensor type and press OK
( ONLY IF CH1.TYp = TeMp)
Verify pt sensor type and press OK
(ONLY IF SeNSOR = pt and CH1.TYp = TeMp)
Verify Ni sensor type and press OK
(ONLY IF SeNSOR = Ni and CH1.TYp = TeMp)
Verify Thermocouple type and press OK
(ONLY IF SeNSOR = TC and CH1.TYp = TeMp)
* Open is shown briefly in the display.
Version No. V5R0
Display shows
aDV.SeT
SeTup
eN.SIL
NeW.paS
CONFIG
Verify
OpeN->LOCK*
CH1.TYp
I.RaNGe
CONNeC
uNIT
SeNSOR
pt.TYpe
Ni.TYpe
TC.TYpe
CJC