PR 9113 Manual De Instalación página 36

LERBAKKEN 10, 8410 RØNDE DENMARK
Ex input
CH1 (terminal 41,42,43,44)
CH2 (terminal 51,52,53,54)
Vt (U ):
o
It (I ):
o
P :
o
Lo/Ro
IIC /
Group A,B
C / C
5 F
a o.
L / L 100 mH
a o.
U :
i
I :
i
C :
i
L
i.
Status Relay. terminal (33,34)
Voltage max:
Power max:
Current max:
Zone 2 installation:
Voltage max:
Power max:
Current max:
Installation notes:
The installation and wiring shall be in accordance with the National Electrical Code NFPA 70,
Article 500 or 505.
The module must be supplied from a Power Supply having double or reinforced insulation.
The use of stranded wires is not permitted for mains wiring except when wires are fitted with
cable ends.
For installation on the 9400 Power Rail the power must be supplied from Power Control Module
Unit 9410.
For installation in Zone 2 or Division 2, the module must be installed in a suitable outer
enclosure having an IP protection of at least IP54.
The module is galvanically isolated and does not require grounding.
Install in pollution degree 2 or better.
Use 60 / 75 ºC Copper Conductors with wire size AWG: (26-14).
Warning: Substitution of components may impair intrinsic safety.
Warning: To prevent ignition of the explosive atmospheres, disconnect power before servicing
and do not separate connectors when energized and an explosive gas mixture is present.
Warning: Do not mount or remove modules from the Power Rail when an explosive gas
mixture is present.
Revision date:
2009-11-27
34
8.7 V
18.4 mA
40 mW
892 μH/
IIB / IIA /
Group C,E,F Group D,G
50 F 1000 F
300 mH 700 mH
10 V
30 mA
30 nF
820 nH
Version Revision:
V3 R0
9113 - Product Version 9113-003
125 VAC / 110 VDC
62.5 VA / 32 W
0.5 A AC / 0.3 ADC
32 VAC / 32 VDC
16 VA / 32 W
0.5 A AC / 1 ADC
Prepared by:
PB
9113QF01
Page:
2/3