Using The Intercom; Introduction; Intercom Compatibility; Before Starting The Intercom - SCHUBERTH SRC-SYSTEM Manual Del Usuario

9. USING THE INTERCOM

9.1 INTRODUCTION

Your SRC-System™ allows you to connect to other bikers using SRC headsets
within a range of up to 700 meters / 2,300 ft. (subject to terrain). To set up one
or two Intercom Bluetooth® connections, you must first pair your SRC-System™
headset with the other headsets.
Pairing is a one time process. Once completed, the headsets will remain paired
and automatically recognize each other whenever they are within range.
Your headset has two Intercom channels available for headset-to-headset
connections. Therefore, your SRC-System™ can communicate simultaneously in
conference mode with up to two other SRC headsets.

9.2 INTERCOM COMPATIBILITY

You can use your SRC-System™ headset for Intercom communication with any
other SRC-System™ headset and with cardo scala rider headsets. For further
details visit www.cardosystems.com/SRC.

9.3 BEFORE STARTING THE INTERCOM

Your SRC-System™ headset has two buttons designated for quick connection to
two other headsets. These other headsets are referred to as CHANNEL "A" and
CHANNEL "B".
Channel "A"
Button
Before you can begin using the intercom for Bike-to-Bike communication with
one or two other headsets, all units must first be paired.
Channel "B"
Button
9.4 USING THE SRC-SYSTEM™ FOR INTERCOM WITH OTHER SRC-SYSTEM™
HEADSETS
INTERCOM CHANNEL PAIRING / CONNECTION
BUTTON
CHANNEL "A" CHANNEL "A" BUTTON
CHANNEL "B" CHANNEL "B" BUTTON
9.4a. TWO-WAY INTERCOM
Using two SRC-System™ headsets
1. While both headsets are turned OFF, turn them ON by pressing and holding
the Mobile Buttons until the Blue Lights flash three times.
2. Make sure that both headsets are now flashing slowly in Blue.
3. Choose an available CHANNEL you wish to use to pair the headset (CHANNEL
"A" or CHANNEL "B").
NOTE: Selecting a CHANNEL that is already in use will override the paired headset on
that CHANNEL with the newly paired headset.
4. On the SRC-System™ headset, press and hold the assigned CHANNEL BUTTON
("A" or "B") for at least six seconds until the headset's BLUE or RED Light be-
gins flashing rapidly, indicating it is in Intercom Pairing mode. (See Intercom
Channel Table for Pairing LED indication for each CHANNEL).
5. Repeat Step 3-4 for the second SRC-System™.
6. Within a few seconds, both headsets will show a solid light for two seconds,
indicating that the two headsets are now paired, connected and ready for use.
NOTE: If the Pairing process is not completed within two minutes the headset will
return to Standby mode.
PAIRING MODE LED
INDICATORS
Rapid RED flashing
Rapid BLUE flashing
17