Wearing And Removing The Helmet; Cleaning The Src-System™ Acoustic Collar; C3 Pro Installation; Removing The Existing Acoustic Collar - SCHUBERTH SRC-SYSTEM Manual Del Usuario

5.7 WEARING AND REMOVING THE HELMET

The electronic components of SRC-System™ are safely embedded inside an
Acoustic Collar. To avoid discomfort while you put on your helmet or while
removing it, we recommend that you proceed as follows:
1. Expand the helmet opening by firmly holding the chin straps and pulling
them forcefully apart.
2. While pulling the straps apart, slide the helmet
over your head.
3. To remove the helmet, proceed along the same
lines by first pulling the straps apart and then
pushing the entire helmet upwards.
NOTE: Your SRC-System™ Acoustic Collar is designed for maximum comfort.
However, since it contains an entire electronic kit within, it will have a slight a bulge.
Therefore, putting your SRC equipped helmet on or taking it off may feel different
than what you are used to with a standard Acoustic Collar. Remember: The more
you pull the helmet straps apart when putting on your helmet or taking it off, the
smoother the process will be, allowing the Acoustic Collar to soften.
5.8 CLEANING THE SRC-SYSTEM™ ACOUSTIC COLLAR
To clean the SRC-System™ Acoustic Collar, first make sure the USB connector is
tightly closed. Use only a slightly damp cloth. Avoid soaking the Acoustic Collar
with water or any other fluid. Never submerge it and refrain from letting water
come in contact with the speakers or the microphone. Allow the unit to dry at
room temperature.
6. C3 PRO INSTALLATION
(See section 5 for S2 installation instructions)

6.1 REMOVING THE EXISTING ACOUSTIC COLLAR

First, remove the existing Acoustic Collar from
your helmet as follows:
1. Open both snap buttons.
2. Pull out the Acoustic Collar from the rear at
its bended center.
3. Release the collar's pins from their
corresponding indentations inside the
helmet's rim.

6.2 CONNECTING THE ANTENNA CABLE

Your SRC-System™ has an antenna cable which must be connected to the built-
in antenna cable connector in the Schuberth helmet.
NOTE: Make sure to close the cover of the USB
connector, and then tuck it away into
the USB connector pocket.
9