Attaching The Src-System; Positioning The Speakers; Positioning The Microphone; Removing The Src-System™ From Your Helmet - SCHUBERTH SRC-SYSTEM Manual Del Usuario

5.3 ATTACHING THE SRC-SYSTEM

1. Make sure to place the speaker and microphone cords inside the helmet, and
then secure the SRC-System™ into place.
2. Push and insert the SRC-System™ starting from the back of the helmet area.
Do the same for the sides of the SRC-System™ and then the front of the
helmet area to secure the SRC-System™ into place.

5.4 POSITIONING THE SPEAKERS

For best audio results, make sure that both of your speakers are placed as closely
as possible just opposite your ears.
The following applies to both sides of the SRC-System™:
1. Open the rear red button located under the interior lining that covers the cheek
pads (the button is held by a black ring). Lift the lining slightly.
2. Attach the corresponding oval Velcro pads to the speaker-shaped indentations
on the EPS (expanded polystyrene) and position the speakers on the Velcro pads.
8
™
3. Close the red button, making sure it is still inside its black holding ring.
NOTE: Optional speaker pads are provided to boost the speaker volume if needed by
bringing the speakers closer to your ears.
To use, simply place the speaker pad between the Velcro pad in the helmet
indentation and the speaker.

5.5 POSITIONING THE MICROPHONE

Locate the spot on the internal padding of the helmet, opposite your mouth,
where the microphone will be placed.
1. Peel the cover from the adhesive Velcro pad and place it on the chosen
location opposite your mouth.
2. Attach the microphone to the Velcro, as shown in illustration.
3. If there is any excess microphone cable, tuck it under the cheek pads.
5.6 REMOVING THE SRC-SYSTEM™ FROM YOUR HELMET
1. Detach both speakers and the microphone from the Velcro on the helmet.
IMPORTANT: Make sure not to pull on the Antenna connector.
2. Pull out the Antenna connector from its pocket and carefully disconnect it.
3. Lift and push the collar's arch from the front helmet area to carefully remove
the SRC-System™ from the helmet.