Reset Pairing (Restoring Default Configuration); Noteworthy Issues; Troubleshooting The Intercom; Click-To-Link® (Ctl) - SCHUBERTH SRC-SYSTEM Manual Del Usuario

ENABLE/DISABLE VOX: VOX activation for Intercom calls can also be disabled
completely. While on standby press the Volume Up and Volume Down Buttons
simultaneously for 3 seconds until you hear a beep. (Default: VOX enabled).
NOTE: The Enable/Disable Voice Connect feature affects only the Intercom functionality.

9.8 RESET PAIRING (RESTORING DEFAULT CONFIGURATION)

This section is only relevant once you have completed a pairing process.
You can delete all of your paired devices at any time as follows:
1. With the SRC-System™ headset turned ON, press and hold the Mobile Button
for at least six seconds until the Red and Blue Lights begin rapidly alternating.
2. Press and hold the Volume Up Button for three seconds.
3. The Red and Blue Lights will flash five times simultaneously and then the
headset will turn off, confirming that Reset was successfully completed.

9.9 NOTEWORTHY ISSUES

1. Busy Status (When using a SRC-System™ headset)
When attempting an Intercom call with a headset that is already on a Phone/
GPS/ Intercom call, you will hear two beeps indicating the other headset is busy.
2. Automatic Reconnection of the Intercom
If the SRC-System™ and another paired headset go out of range and disconnect
from each other, the SRC-System™ will immediately try to reconnect to the
other headset.
You can manually reconnect the intercom call while the headset is in Standby
mode by pressing the CHANNEL "A" or the CHANNEL "B" Button to connect to the
respective lost connection.
3. Conference Mode Limitations
Whenever you enter the Intercom Conference mode among three participants
(including yourself), the participants who maintain simultaneously two active
connections will not be able to receive mobile phone calls or GPS messages as
long as the conference call is in progress (see details in sections 9.4 b).

9.10 TROUBLESHOOTING THE INTERCOM

First, make sure your microphone is located properly in front of the center of your
mouth.
The SRC-System™ is designed for use in loud environments. Therefore, you
should test the Intercom functionality only in a noisy environment, such as next
to an idling motorcycle and not indoors. Please also verify that the headsets
were paired together properly by following the instructions in the relevant Setup
sections.
10. CLICK-TO-LINK® (CTL)
Click-to-Link® is the spontaneous "social" nature of your SRC-System™. This unique
feature will enable you to instantly initiate one-to-one intercom calls with other
SRC-System™ users in the near vicinity without going through a pairing process in
advance. Think of it as a private bike-to-bike channel that you can set up on-the-fly
with other SRC-System™ users that you spot at a traffic light or on the road.
The Click-to-Link® feature can of course be disabled at any time, blocking any
attempt by other users to establish a spontaneous link.
ENABLE/DISABLE CLICK-TO-LINK®
The feature can be turned on or off via the Settings Customization Menu (see
Section 4.4). By default, this feature is DISABLED.
AUDIO SOURCES AND PRIORITIES
The different audio sources connected to the SRC-System™ are prioritized as
shown below, i.e. the higher priority source will always override and interrupt
the lower one.
For example, incoming mobile phone calls and GPS navigation instructions will
interrupt ongoing Click-to-Link® calls, while incoming Click-to-Link® calls will
interrupt the audio from the built-in FM Radio etc.
Click-to-Link® established calls and Intercom calls have the same priority: If one is
in use, the other is unable to interrupt. Therefore, a Click-to-Link® request cannot
interrupt an Intercom call in progress, and vice-versa.
19