Calling Of Individual Time Programmes; Plasticizing Of Blanks With Unknown Heating Times; Abort/Termination Of Programme - Dreve Drufosmart scan Instrucciones De Trabajo

9.3 Calling of individual time programmes

Turn on the unit – the initial display
will be visible. By pushing the menu
key (j) several times you may select one
after another:
a) enter modus
b) F1
c) F2
d) F3
By pressing the menu keys (d/j) you may
navigate arbitrarily between the a. m.
programme points. Confirm the selected
programme point with the OK key (f).

9.4 Plasticizing of blanks with unknown heating times

Create an individual time programme
with high heating and cooling times
(see point 9.2). Start the programme
(see point 8.2). You may test the
plasticization degree of the blank by
means of an edgeless metal instrument
(e. g. wax knife).
Info
The complete deformability of the
blank can only be tested at the
edges, as that is where warmth
will leak through the metal con-

9.5 Abort/termination of programme

During an active time programme the
key pad is deactivated. It is possible
to abort/terminate all actions of the
Then go on as described in point 8.2.
tacts and the necessary flexibility
will be attained at last!
After the blank has attained the neces-
sary flexibility initiate the thermoform-
ing process (see point 8.4). The remain-
ing heating time will be erased from
the display (a) and the adjusted cooling
time will be counted down (c).
The cooling time can be terminated at
any time by pulling the heating han-
dle (5).
Drufosmart scan by pulling the heat-
ing handle (5) as far as it will go (for
approx. 3 seconds).
39