Assembly & Operation - Worx WG770E Manual Original

INTENDED USE
This product is intended for domestic lawn
mowing.
ASSEMBLY & OPERATION
Action
ASSEMBLE
Assembling the handle bar
Adjustment Handle's height
Assembling the grass
collection bag
Assembling the Grass
Collection Bag to the Lawn
Mower
REMOVING/EMPTYING the
Grass Collection Bag
Installing
Side-discharge chute
Installing Mulching Plug
Removing the battery pack
Note: The Battery Pack is
14
shipped uncharged. The
Battery must be fully charged
before the first mow.
Checking the battery charge
condition
Charging the battery pack
More details can be found in
WA3735's manual
Fitting the battery pack
Note: The mower can be
used with one or two battery
pack(s).
OPERATION
Starting
Stopping
Cordless Lawn Mower
Selecting the WORK MODE
DIAL
ECO MODE
Select ECO mode when
mowing in everyday
conditions when the
maximum grass height is
Figure
20mm or less.
TURBO MODE
Set the dial to TURBO mode
when cutting dense or
See Fig. A1
overgrown grass.
See Fig. A2
Battery Power indicator on
machine
See Fig. B
Adjusting The Cutting Height
See Fig. C1,
Cleaning The Mower
C2, C3
WARNING: Plug the hose on
the Washout port first, then
start the mower.
See Fig. C4
Storage
See Fig.D1, D2
MULCHING MOWING TIPS
While mulching, your new mower is
See Fig. E
designed to cut the grass clippings into
small pieces and distribute them back into
the lawn. Under normal conditions, the
See Fig. F1
mulched grass will biodegrade quickly and
deliver nutrients to the lawn. Please review
the following recommendations for optimum
mulching performance.
See Fig. F2
1) Avoid mowing when the grass is wet
See Fig. F3
See Fig. F4
2) For the best mulching performance, set
See Fig. G1, G2
See Fig. G3
from rain or dew. Wet grass may form
clumps which interfere with the mulching
action and reduce the runtime. The best
time to mow the grass is in the late
afternoon when the grass is dry and the
newly cut area will not be exposed to
direct sunlight.
the cutting height to remove about one
third of the grass blade length, ideally no
more than 40mm at one time. If the lawn
is overgrown, it may be necessary to
increase the cutting height to reduce the
pushing effort and prevent overloading
the motor. For extremely heavy mulching,
it is advisable to first cut at a high cut
height setting, and then re-cut to the final
See Fig. H
See Fig. I
See Fig .J
See Fig. K
See Fig. O1,
O2, O3
EN