Jacuzzi YOUNG COLLECTION PROJECT Uso Y Mantenimiento página 12

i
C
1
The blower (or... the "magic bubbles")
(mod. AIR, DUO, DUO+DISI)
I Fill the tub up with the same amount of water that you would
use for a normal bath.
I If you have not already done so, turn on the main switch lo-
cated on the power supply line of the tub.
I With your finger, touch (for at least half a second) any key on
the display: the screen will light up, showing the system is s-
tanding by to receive commands
NOTE: if you do not touch any key for 2 minutes, the screen
will go off. Touch any key again to re-activate it. Keep in mind
that if two keys are accidentally touched at the same time, y-
ou will need to wait about 3 seconds before you will be able
to activate another command.
i
I
( ) Press key "A" to start the function. The key will light
1
up blue and the blower will be activated at half-power
NOTE: if the level of water in the tub is insufficient, the light
will flash for about 2 seconds, and for about 30 seconds there
will be an acoustic signal to inform you that the function can-
not be activated. You must add water and press key "A" again.
I After 20 minutes, the function comes to an end and the blue
light goes off. You can however stop the function anytime y-
ou wish by pressing the key (A).
Changing the quantity of air bubbles
I
i
If you want to change the quantity of bubbles, use keys "B"
or "C" ( ), respectively to increase or decrease the
1
power of the blower. You can press the key once, or you can
hold it down until you get the desired effect.
Drainage of the blower circuit:
after about 30 minutes after the tub is emptied (when the sen-
sor no longer detects water in the tub) the blower is auto-
matically activated for about 30 seconds. This is to force out
any remaining water (which got in while filling the tub) from
the pipes connected to the nozzles on the bottom of the tub.
T H E YO U N G C O L L E C T I O N
B A
in models with a blower,
You can activate this phase manually if you like, without hav-
ing to wait the 30 minutes previously mentioned:
- wait for the tub to drain completely.
- Touch key "A" with your finger. The blower will come on for
30 seconds, and then you can turn off the main switch locat-
ed on the power supply line of the tub.
NOTE: the phase for cleaning the pipes can be activated on-
ly once, again with the tub empty, unless you reset the elec-
tronics via the main switch. If you turn the main switch off and
back on, you can re-activate the blower (by pressing key "A")
even if there is an insufficient amount of water in the tub.
However, the function will shut off automatically after the 30-
second period referred to previously; basically, the pipe-clean-
ing phase is activated. If you want to use the blower function,
you will need to fill the tub correctly.
i
2
T H E YO U N G C O L L E C T I O N
i
3
The hydromassage
(mod. JET, JET+DISI, DUO, DUO+DISI)
i
I
( ) Fill the tub to the indicated level (about 5-6 cm over
2
the uppermost jets).
I Before you get in the tub, make sure that the jets (HydroJet),
which are direction adjustable (if installed) are pointed where
you want them.
12
E D