Hog Slat GROW-DISC HSCD200 Manual De Instalación Y Operación página 20

GROW-DISK™ Feed System
12. ACTUATOR OPEN TIME: Default 00:30 seconds – When ACTUATOR is selected as the feed
dump mechanism, the ACTUATOR OPEN TIME is the amount of time the open signal is sent to
the actuator. This value can be set to whatever the amount of time needed for the actuator to
reach the full open point of the feed drops. The Close time is 2X the Open time to ensure the
actuator is fully closed and activating the Security switch if so equipped.
13. ARROW – Press RIGHT arrow to advance to next page. Use LEFT arrow to back up a page.
14. SET-UP HELP: Press this button for an on-screen list of suggestions for controller set-up.
SETTINGS 3 OF 3:
1. FEED SENSOR TYPE?: Default N OPEN (Normally Open) Feed sensor is "CLOSED" when
detecting feed. N CLOSED (Normally Closed) Feed sensor is "OPEN" when detecting feed. Most
installations the feed sensor (proximity switch) type is Normally Open. Therefore when the feed
sensor detects feed, the STATUS screen item #6 will indicated FEED DETECTED.
2. F.S. IN LAST DROP?: Default "NO" – Feed Sensor location. Selects whether the Feed Sensor
(proximity switch) is in the Last Drop or in the chain disk pipe. If "YES", the FEED CYCLE
DELAY timer will start once feed has dropped away from the face of the sensor. If "NO", the
FEED CYCLE will start immediately after the feed cycle completes.
3. TOGGLE FUNCTION?: Default "STOP" – Defines the function of an external toggle switch that
may be used to stop a feed system remotely. WARNING: TOGGLE SWITCH DOES NOT
DISCONNECT POWER, DO NOT SERVICE EQUIPMENT USING THE TOGGLE SWITCH AS
DISCONNECT. ALWAYS DISCONNECT POWER FROM SOURCE BEFORE SERVICING. If the
setting is "STOP", switching off the TOGGLE SWITCH will stop the current feed cycle. Switch the
TOGGLE SWITCH back on will enable the controller but will not restart the feed cycle. If the
setting is "CONT." (Continuous) then the TOGGLE switch acts like a pause switch. When the
TOGGLE is off the feed cycle will pause at its current status. Once the TOGGLE is on the feed
cycle will resume where it left off.
4. FEED DUMP?: Default "NO" – Defines whether a feed dump mechanism is used or not. If "YES"
is selected, the manual operation will be visible in the OPERATION MODE screen.
Hog Slat Inc. Newton Grove, NC USA
1
2
3
10
March 2019 REV A5
4
5
6
7
8
9
20