Zhermack SAND Manual De Instrucciones página 127

MAINTENANCE AND USE MANUAL
Fig. 5: Replace the lids (2) on both tanks (3 and 3I) and
re-tighten the relative tank closure knobs (1) by turning
them clockwise.
Before closing the lids, clean the tank edges
carefully to remove any sand residue and so
prevent wear on the seals.
Fig. 6: Switch on the sandblasting equipment at the
main switch (5): at the same time switch on the neon
light (19). Open the glass hatch (18) by pulling the
lower extremity upwards, making sure that the hinges
(7), on both sides, click into place in the vertical
position.
Fig. 7: Use the switching device (25) to select the
desired nozzle type:
0. Neutral position
1. Blue right-hand cylinder (3)
2. Black left-hand cylinder (3I)
Fig. 8: Lower the glass hatch (18), press the air control
pedal (24) and set pressure by rotating the knob (6)
clockwise slowly until the desired pressure, shown on
the gauge (4), is obtained.
It is recommended that you use a maximum pressure of 6 bar for the 60/110 µm (3)
tank and 4 bar for the 110/250 µm (3I) tank.
SAND S 23 / S 24 / S 24 R / S 25 / S 25 R
EN
Figure
Figure
0
25
2 - Black
Figure
Figure
127 of 176
5
6
1
Blue
7
8