Initial Start-Up - clage M 3-O Instrucciones De Operación E Instalación

Installation
M 3, M 4 (230 V)
Fig. 8: "Circuit diagram"

3.6 Initial start-up

Do not switch on the electric power at this time!
1. To purge the instantaneous water heater, open the hot water tap and wait until the water
emerges free of air bubbles.
2. In order to obtain an optimum water jet at low flow rates, screw the enclosed special tap
aerator into the tap outlet.
(When installing a shower the special hand shower M/BGS is used instead.)
Fig. 9: "Fitting the special tap aerator"
3. Switch on the electric power.
4. Adapt the water flow if necessary, if for example the temperature is not reached. The proce-
dure is described in the chapter "Use".
5. Explain the functions and use of the instantaneous water heater to the user and hand over
these operating instructions to the user for information and future reference.
6. Register the appliance with the customer service department using the registration card or
online at www.clage.com.
M 6 (230 V)
29
CLAGE
M 7 (400 V)
EN