Tritech T7 Manual De Instrucciones página 42

Pressure Relief Procedure
The sprayer's pressure must be manually relieved to prevent sprayer from starting or spraying
accidentally.
Fluid under high pressure can be injected through skin and cause serious injury. To reduce risk of injury
from injection, splashing fluid, or moving parts,
Follow the Pressure Relief Procedure whenever you:
• are instructed to relieve pressure
• stop spraying
• check or service any system equipment
• install or clean spray tip
Turn pressure control knob counterclockwise to stop.
2. Turn sprayer off.
3. Unplug power supply cord.
4. Hold metal part of gun firmly to grounded metal container. Trigger gun to relieve pressure.
5. Lock gun safety latch.
6. Open prime valve. Leave prime valve open until ready to spray again.
NOTE: Do not store unit for extended periods of time with the Pressure relief valve open. Store the unit
in the spray position.
NOTE: If suspected that spray tip or hose is completely clogged, or that pressure has not been fully
relieved after following steps above,
SLOWLY loosen tip guard or hose end coupling to relieve pressure gradually, and then loosen
completely. Clear tip or hose obstruction.
EXTENSION CORD VOLTAGE DROP
120V 15 AMP
14 AWG
12 AWG
10 AWG
LINE LOSS 1/4" HOSE STANDARD LATEX PAINT
HORIZONTAL
50' 3300PSI
100' 3300PSI
150' 3300PSI
200' 3300PSI
250' 3300PSI
300' 3300PSI
VERTICLE
50' 3200
100' 3200
150' 3200
200' 3200
250' 3200
300' 3200
100' 200'
110.6 101.2
114.1 108.1
116.3 112.5
AT PUMP AT TIP
227 BAR
3150
227 BAR
3100
227 BAR
3050
227 BAR
3000
227 BAR
2950
227 BAR
2900
220 BAR
3135
220 BAR
3070
220 BAR
3005
220 BAR
2940
220 BAR
2875
220 BAR
2810
300'
91.8
102.2
108.8
217 BAR
213 BAR
210 BAR
207 BAR
203 BAR
199 BAR
216 BAR
211 BAR
209 BAR
202 BAR
198 BAR
193 BAR