Publicidad
Idiomas disponibles
Idiomas disponibles
MUSIC SENSOR
If there is a 4-second or longer blank between each track, a
search for the beginning of the current or next track during
playback can be done easily.
When > of 4
button is flashing, press -to
move to the
next track or -
to move to the beginning of the current track.
When < of
F button is flashing, press U
to move to the
next track, or *to
move to the beginning of the current track.
The search function may not be able to detect tracks under the
follwing conditions:
Blanks of less than 4 seconds between tracks
Noisy blanks
Long passages of low-end sound
Low overall recording levels
After playback on one deck finishes, the tape in the other deck
will start to play without interruption.
1
2
3
4
insert tapes into deck 1 and deck 2.
Press TAPE/DECKl/2
to select the deck to be
played back first.
Press REV MODE(DECK
2) to select =2.
Press +*
to start playback.
Playback continues until fi is pressed.
About cassette tapes
* To prevent accidental erasure,
break off the plastic tabs
on the cassette tape after recording with a screwdriver or
other pointed tool.
1>
Type II tape
Tab for side A
detection
slot
To record on the tape again, cover the tab openings with
adhesive tape, etc. (On Type II tapes, take care not to cover
the Type
II
tape detection slot.)
120-minute or longer tapes are extremely thin and easily
deformed or damaged. They are not recommended.
Take up any slack in the tape with a pencil or similar tool
before use. Slack tape may break or jam in the mechanism.
DOLBY NR system
The Dolby Noise Reduction system reduces tape hiss noise.
For optimum
performance
when playing
back a tape
recorded with the DOLBY NR system, turn on the DOLBY
NR system.
ENGLISH
18
Publicidad
