Aiwa NSX-D9 Manual De Instrucciones página 20

This section explains how to record from the tuner, CD player,
or external equipment.
Preparation
Set the tape to the point where recording will start.
Use Type I (normal) and Type
II
(high/CrOz) tapes for recording.
1
2
3
4
5
Insert the tape to be recorded on into deck 2.
Insert the tape with the side to be recorded on first facing out
from the unit.
— = PUSH EJECT
Press REV MODE(DECK 2) to select the reverse
mode.
To record on one side only, select =.
To record on both sides, select =) or C=).
Press DOLBY NR to turn Dolby NR on or off.
To record with DOLBY NR, turn on 00 NR.
To record without DOLBY NR, turn off DO NR.
Press function (CD, TUNER/BAND, VIDEO/AUX or
MD) and prepare the source to be recorded.
To record from a CD, press CD and load the disc(s).
To record from a radio broadcast, press TUNEWBAND and
tune in to a station.
To record from a connected source, press VIDEO/AUX or
MD.
Press REC/REC MUTE to start recording.
When recording from a connected source, start playback of
the source.
When the selected function is CD, playback and recording
start simultaneously.
19
ENGLISH
To stop recording, press .
To pause recording, press II. (Applicable when the source is
TUNEWBAND, VI DEO/AUX or MD.) To resume recording, press
again.
To start recording with the remote control
First press
/0 REC/ REC MUTE, and then press +> within
2 seconds.
The output volume of the speakers or headphones maybe freely
varied without affecting the level of the recording. But BBE and
Rhythm play function (BEAT, AUTO SPICE/FILL IN, SPICEA/B)
will affect the recording.
Recording with BBE
The desired source can be recorded with the BBE function to
enhance the clarity of high-frequency sound, When playing back
a tape recorded with BBE, it is recommended that BBE be set to
off .
——t
TNSERTING BLAFK=S
Insertion of 4-second blank spaces enables you to activate the
Music Sensor function. (Applicable when the source is TUNER,
VIDEO/AUX or MD.)
1 Press REC/REC MUTE during recording or while in
recording pause mode.
= on the display flashes for 4 seconds and the tape runs
without recording. After 4 seconds, the deck enters the
recording pause mode.
2 Press 11 to reeume recording.
To insert a blank space of less than 4 seconds, press @
REC/REC MUTE again while ~ is flashing.
To insert blank spaces of more than 4 seconds, after the
deck enters recording pause mode, press REC/REC MUTE
again, Each time the button is pressed, a 4-second blank space
is added.
"Can't REC is displayed if you attempt to record on a tape with
the plastic tabs broken off.
To erase a recording
Make sure the microphone(s) is(are) not connected to this unit
and set the microphone volume and the echo level to OFF. (page
23). Also, check to make sure that BEAT and AUTO SPICE are
switched off [~aae 8).
1
2
3
4
Insert the';a~e to be erased into deck 2 and press TAPEI
DECK 1/2 to display '(TP 2".
Set the tape to the point where the erasure is to be started.
Set the reverse mode by pressing REV MODE (DECK 2).
Press REC/REC MUTE to starl the erasure.