Aiwa NSX-D9 Manual De Instrucciones página 21

Preparation
Set the tape to the point where recording will start.
The reverse mode is automatically set to Z. Note that recording
will be done on one side of the tape only.
1
2
3
4
5
Press TAPIVDECK 1/2.
Insert the
original tape
into deck 1 and the tape
to be recorded on into deck 2.
insert the tapes with the sides to be played back or recorded
on facing out from the unit.
Press DOLBY NR to turn off the Dolby NR.
tl NR on the display goes out.
Press TAPE/DECK 1/2 to select deck 1.
"TPI" is displayed.
Press REC/REC MUTE to start recording.
Playing and recording start simultaneously.
To stop dubbing
Press
.
This function allows you to make exact copies of both sides of
the original tape. The reverse side of both tapes will start
simultaneously as soon as the longer tape has been reversed.
Dubbing does not start from a point halfway in the tape.
The reverse mode is automatically set to Z).
The Dolby NR does not affect recording.
7 Press TAPE/DECK 1/2.
2 insert the original tape into deck 1 and the tape
to be recorded on into deck 2.
Inseri each tape with the side to be played back or recorded
on first facing out from the unit.
3 Press SYNC DUB once or twice to start recording.
@)
For recording at normal speed, press it once to display
"NORM-DUB.
@ For recording at high speed, press it twice to display
"HIGH-DUB.
The tapes are rewound to the beginning of the front sides,
and recording starts.
To stop dubbing
Press .
Recording does not start, if the erasure prevention tab on either
side of the tape is broken off.
If the leader segment of the tape to be recorded on is longer
than that of the original tape, recording on the reverse side
may stop midway through the recording. In this case, dub each
side manually following the procedure in "DUBBING A TAPE
MANUALLY.
ENGLISH 20