Cinstalling The Iso Chair; Backrest; Backrest Upholstery - eurodent ABSOLUTE Guia De Instalacion

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

C
INSTALLING THE ISO CHAIR
C1
C2
C3

BACKREST

Remove the chair from the packing by cutting along the
dash-line, and lift the backrest until the hitch point
matches the push rod.
Carefully insert the shim in its housing, and after fitting
the screw in its housing, tighten it with the suitable
wrench.
Now the chair can operate and some test movements
should be performed to ensure that stop microswitches
operate properly.
Then proceed by mounting upholstery.

BACKREST UPHOLSTERY

Position upholstery slightly over the backrest and make
it slip down so that it fits in the two fastening screws.
When upholstery is properly positioned, fit the screw into
the suitable hole on the back side and tighten the M4
dowel by using the 2 mm Allen wrench.
If the pad does not match properly with the backrest,
adjust the two flathead screws as described for the
headrest pad.
31
ABSOLUTE
Installation instructions

Publicidad

Tabla de contenido
loading

Tabla de contenido