Diagrams, Motor Overload, Switch Settings - ITT Goulds Pumps AquaBoost II 1AB2 Instalación, Operación Y Mantenimiento

Diagrams
Section 8
Section 8
Motor Overload and Application Switch Setting
Example: For 30 Hz
minimum speed and
medium ramp setting,
set application switch
setting as indicated.
Danger
When the unit is powered, the Motor Overload and Application Setting Switches are at a
DANGER
high voltage potential. Always turn off the disconnect switch and circuit breaker and wait
Hazardous
voltage
5 minutes before touching the Motor Overload or Application Setting Switches.
Diagram 3
AquaBoost II Wiring Diagram
Input
230V
1 Phase
Line input power from
2-pole disconnect or
circuit breaker.
Diagram 4
See Manual For
Switch Settings
Output
Motor
To Motor
Applic.
Overload
Type
Setting
1 2 3 4 1 2 3 4
11
Example: If motor
nameplate service
factor amps = 3.3 A for
1AB2 or 5.3A for 2AB2,
set motor overload
switches as indicated.
Pressure
Sensor
Line output to motor.
Correct motor rotation
determines order of colors.
Pressure
Sensor
7K2100