Master Forge 3218LTN Manual De Instrucciones página 48

TROUBLESHOOTING
Sudden drop in
gas flow or low
flame.
Cooking light will
not turn on.
LED control panel
lights do not light
up.
1. Out of gas.
2. Excess flow valve
tripped.
3. Vapor lock at coupling
nut/LP cylinder
connection.
1. No power supply.
2. Defective Halogen bulb.
3. Internal wiring issue.
1. No power supply.
2. Damaged wiring or loose
connection.
3. Wiring not attached to
control panel switch.
4. Defective switch.
5. Defective LED's.
1. Check for gas in LP cylinder.
2. Turn off knobs, wait 30 seconds and
light grill. If flames are still low, turn
off knobs and LP cylinder valve.
Disconnect regulator. Reconnect
regulator and leak test. Turn on LP
cylinder valve, wait 30 seconds and
then light grill.
3. Turn off knobs and LP cylinder valve.
Disconnect coupling nut from
cylinder. Reconnect and retry.
1. Check power supply and make sure
transformer is properly plugged in.
2. Replace the bulb.
3. Check the wiring connections under
the fire box. All wire connections must
be tight. If any wires are damaged they
should be replaced.
1. Install AA batteries in the LED battery
box.
2. Check all wiring connections between
the battery box and the LED light. Also
check the connections between the
LED's on the control panel.
3. Check the connection between the
LED light and the LED light switch.
4. Replace the switch.
5. Replace the LED lights.
Lowes.com/masterforge
48