Nuova Simonelli Appia II Compact Manual De Instrucciones página 49

EN
7.9 AUTOMATIC GROUP
CLEANING CYCLE
To start the automatic cleaning mode, the machine
must first be switched off and then back on again
while holding down the hot water
coffee from group 2
At the end of the Flash-test, the
and the single long coffee key
begin to flash.
Press the key to start the washing cycle for the
relevant group.
Once the washing cycle has been completed, it is
possible to perform a rinse cycle for the same group
by pressing the key again.
To perform the rinse cycle at a later time, switch off
the machine and the card will store any cleaning
cycles that need to be completed in its memory. In
fact, the next time that the machine is switched on,
the machine card will automatically open the group
cleaning status without it being necessary to press
the
and keys.
Hold down the and
exit the cleaning mode in the event that there are
no cycles to be completed. For incomplete cycles,
the keys of the groups that require rinsing will
continue to flash.
Hold down the and
to force exit from the cleaning mode, resetting all
information about rinse cycles still to be completed.
When a cleaning cycle is complete, the
the group will switch off.
If there are no more rinse cycles to be performed, the
card will exit the cleaning mode.
and one low
during the initial Lamp-test.
and keys
of all groups will
keys for 2 seconds to
keys for 2 seconds more
key for
45