Victron Energie BMV-700 Manual De Instrucciones página 21

When power is applied for the first time or when factory settings have
been restored, the BMV will start the quick setup wizard: see section 1.
Thereafter, if power is applied, the BMV will start in normal mode: see
section 2.
4.2 Functions overview
The following summary describes all the parameters of the BMV.
- Press SETUP for two seconds to access these functions and use the
+ and – buttons to browse them.
- Press SELECT to access the desired parameter.
- Use SELECT and the + and – buttons to customize. A short beep
confirms the setting.
- Press SETUP at any time to return to the scrolling text, and press
again to return to normal mode.
4.2.1 Battery settings
______________________________________________________________
01. Battery capacity
Battery capacity in amp hours
Default
200Ah
______________________________________________________________
02. Charged Voltage
The battery voltage must be above this voltage level to consider the battery as fully
charged.
The charged-voltage-parameter should always be slightly below the end of charge voltage of the
charger (usually 0.2V or 0.3V below the 'float' voltage of the charger).
See section 3.7 for recommended settings.
BMV-700 / BMV-702 / BMV-712 Smart
Default
See table, sect 3.7
BMV-700H
Default
158,4V
______________________________________________________________
03. Tail current
Once the charge current has dropped to less than the set tail current (expressed as
percentage of the battery capacity), the battery is considered as fully charged.
Remark:
Some battery chargers stop charging when the current drops below a set threshold. The tail current must
be set higher than this threshold.
Default
4%
Range
1 – 9999Ah
Range
0 – 95V
Range
0 – 384V
Range
0,5 – 10%
Step size
1Ah
Step size
0,1V
Step size
0,1V
Step size
0,1%
19