Replacing The Camber Tube - Ki Mobility Little Wave Clik XP Manual De Instrucciones Y Garantía

V. SET UP & USE OF YOUR WHEELCHAIR
M. Replacing the Camber Tube
To replace the camber tube on your Clik wheelchair:
1. Remove existing camber tube following removal instructions in Section L.
2. Starting on either the left or right side of chair, slide end of new camber tube through camber
clamp. If your chair has a Standard or Dynamic 5th wheel, refer to corresponding steps
below (a - e) before moving on to step 3. If your chair does not have a Standard or
Dynamic 5th wheel skip to step 3.
Instructions for installing STANDARD 5th wheel receiver on camber tube (Refer to Fig. 15 on
previous page):
a. Slide 5th wheel receiver onto end of camber tube that has already been inserted through the
camber tube clamp. Receiver should be below camber tube with notched face towards rear
of chair.
b. Slide camber tube into the opposite side camber clamp.
c. Slide receiver to center of camber tube and align hole in tube and receiver to accept 6mm
bolt.
d. Insert 5mm bolt (Fig. 15:A) into aligned holes. Secure with 5mm nut on back side. Tighten
securely.
e. Tighten 6mm clamping bolts at top of receiver (Fig. 15:B). Move to step 4 on next page.
Instructions for installing Dynamic 5th Wheel receiver on camber tube (Refer to Fig. 16 on
previous page):
a. Slide 5th wheel receiver onto end of camber tube that has already been inserted through the
camber tube clamp. Receiver should be below camber tube with threaded barrel (Fig. 16)
facing front of chair.
b. Slide camber tube into the opposite side camber clamp.
c. Slide receiver to center of camber tube and align two holes in tube and two holes in receiver
to accept 6mm bolts (Fig. 16:A).
d. Insert 6mm bolts (Fig. 16:A) into aligned holes. Secure with 6mm nuts and flat washers on
back side. Tighten securely. Move to step 3.
27