Removing Adjustable Backrest Rigidizer Bar For Width Adjustment - Ki Mobility Little Wave Clik XP Manual De Instrucciones Y Garantía

V. SET UP & USE OF YOUR WHEELCHAIR
Y. Removing Adjustable Backrest Rigidizer Bar for
Width Adjustment
To remove your adjustable backrest rigidizer bar when growing the width of your Clik:
1. Remove back upholstery by removing Phillips head screw from each side at top of back
upholstery. Slide upholstery off backrest tubes and set aside. Note position of adjustable
rigidizer bar and back tubes for reinstalling after width adjustment.
2. Remove two 5mm screws from each side of adjustable backrest rigidizer bar (Fig. 34:A). (Use
of two 3mm Allen wrenches for this adjustment is required.)
3. Using Allen wrench, push the two threaded barrels on each side of adjustable backrest
rigidizer bar through screw holes.
4. Slide rigidizer bar off backrest tubes. Set aside.
Fig. 34
A
DANGER: Do not use or operate wheelchair when adjustable backrest rigidizer is not installed.
Failure to heed these instructions may result in severe injury or death.
B
40
A