Publicidad
Idiomas disponibles
Idiomas disponibles
SERVICE AND ADJUSTMENT
HOW TO LEVEL THE MOWER
HOUSING
If the mower
housing
is level, the blade will cut easier
and the lawn
will look better.
WARNING: Before you make an inspection,
adjust-
_
ment, or repair to the unit, disconnect the wire to the
spark plug. Remove the spark plug wire to prevent
the engine from starting by accident.
1.
Make sure the unit is on a hard flat surface.
2.
Check
the air pressure
in the tires.
If the air pressure
is incor-
rect, the mower
housing
will not cut level.
Make sure the tires
are inflated
to: Front Tires 22 PSI (1.5 BAR), Rear Tires 14 PSI.
(1 BAR).
3.
Open the cover
(see Figure
25).
4.
Move the lift lever
to the LEVEL
ADJUSTMENT
position
(see
Figure
25).
5.
Loosen
the front and rear adjuster
knobs
(see Figure
25 and
Figure
26). Make sure both sides of the mower
housing
are set-
ting on a flat surface.
Also,
make sure the lift links and adjuster
plates are loose and can easily
move up or down.
Level Ad
Position
Lift Lever
\
Cover
Cutting Height
Positions
Rear Adjuster Knob
Front
Adjuster Knobs
6.
Tighten
the front and rear adjuster
knobs.
Make sure the ad-
juster
knobs
are tight. If necessary,
use a wrench
to tighten the
adjuster
knobs.
For
plastic
adjuster
knobs,
tighten
to a
torque
of 7 foot pounds
(9,5 N-m).
For metal adjuster
knobs,
tighten
to a torque
of 10 foot pounds
(13,5
N-m).
7.
Raise the lift lever from the LEVEL ADJUSTMENT
position
to
a CUTTING
HEIGHT
position
(Figure
27).
8.
Close the cover.
9.
Mow for a short distance.
If the height of cut is not level, repeat
the above
steps.
CAUTION:
Do
not operate
with
the
mower
housing
in the
LEVEL
ADJUSTMENT
position,
If you operate
in the LEVEL
ADJUSTMENT
position,
the mower
housing
and blades
can be
damaged.
Figure 25
Figure 26
Cutting Height Positions
Figure 27
F-040603L
26
Publicidad
