Festo DGC-8 Serie Instrucciones De Utilizacion página 21

DGC-8/12
Fitting centre supports
Position the centre supports type MUC-...
S
on the DGC-... in accordance with Fig. 12
and 13.
Make sure that the centre supports are
S
outside the positioning range of the slide
by pushing the slide once over the com-
plete positioning path (especially with
side-fitted centre supports, see Fig. 13).
For all applications:
Place the DGC-... so that all the operating
S
parts are accessible.
Tighten the fastening screws to an equal
extent.
If an additional guide is used for the work
load:
Make sure that a degree of freedom is
S
maintained between the slide and the
work load.
Use the driver type FKC-... for ensuring
that there is a degree of freedom between
the axis and the guided work load.
For all applications:
Place the work load so that the tilting
S
torque of the force parallel to the move-
ment axis and lever arm a remains low.
Take into account here the values from
Figs. 22 and 23 (in particular r
be exceeded).
Make sure that the torque loading of the slide does not exceed the permitted
S
values in accordance with the chapter "Technical specifications" (Mx, My, Mz)
when the work load is fastened.
Tightening torques for the slide holes: DGC-..-G: 2 Nm; DGC-..-KF: 2.5 Nm.
Festo DGC-8/12 0212NH English
Fig. 12
m
Fig. 13
Fig. 14
Fig. 15
should not
o
1,2 Nm
m
F
a
21