Festo DGC-8 Serie Instrucciones De Utilizacion página 23

DGC-8/12
Place the proximity switches as follows:
S
End position
Slide position
left
(s (see Fig. 16: Fi 16
"L")
Slide position
right ("R")
Fig. 18
In this way, you take into consideration the fact that the switching magnet is
arranged asymmetrically (left) on the slide.
If there is a continuous signal:
S Check to see if the proximity switch has been fitted the right way.
With DGC-8-KF/G:
Please note that proximity switch SME-10-KL (SL) in slide position 'left' with
S
the cable exit to the centre of the cylinder switches up to 1.2 mm before the
end position.
6 Commissioning
Commissioning the complete system
Slowly pressurize the complete system.
S
In this way you will prevent sudden un-
controlled movements.
For slow start-up pressurization, use
safety start-up valve type HEL-... /
type HEM-... .
Festo DGC-8/12 0212NH English
SME-10/SMT-10-KL (SL)
Cable exit to cylinder centre
necessary
Mounting position as desired
SME-10/SMT-10-KQ (SQ)
Fastening screw faces end
position cover
HEL-...
QH-...
Fig. 19
23