Publicidad
Idiomas disponibles
Idiomas disponibles
6600
The instruction manual is downloadable from the site www.vimar.com
DESCRIPTION
Types 6611/AU, 661C/AU, 6711/AU are a intercommunicating 6600 series
open-voice interphone for ELVOX 2-WIRE door entry systems.
Type .../F versions have the same features and are programmed and in-
stalled in the same way.
The interphones are supplied as standard with 6 push-buttons for auxiliary
functions or intercommuncating calls, 8 push-buttons for the following fun-
ctions: door lock release, interphone self-start in the system even when
it has not been called, conversation, stair light, internal voice line volume
control, ringtone volume control, and two for the ringtone type. Two LEDs
(red and green) on the interphone serve to indicate the following states: call
signal mute, unanswered calls, services not available and gate/door open.
- Flush-mounting of the interphone (Art. 6611) requires the use of flu-
sh-mounted back box type 6149.
- The installation of the surface wall-mounted monitor (type 6711) requires
the bracket for the wall-mounting supplied as standard.
Fig. 1
N
D
F
RESET
G
C
L
Video interphone technical specifications
- Interphone in ABS.
- Removable terminal block.
- Electronic circuit on interchangeable cards.
- Operating temperature from 0° to +40° C.
- Electronic ringtone.
- Input for landing calls with different ringtone from entrance panel calls.
- Output for additional ringtone type 860A.
- Supply voltage provided by bus.
Controls and adjustments
B) Microphone.
C) Loudspeaker.
D)
Pair of push-buttons.
2) When the interphone has not self.starter, the push-buttons can be
used to select the tune for calls from a speech unit only. To programme
the tune: hold down 1 of the 2 push-buttons for at least 2 second, then
press the push-buttons repeatedly to select the desired tune.
E)
Pair of push-buttons.
1) During conversation, with push-button "I" pressed, press push-buttons
"D" to increase or decrease the volume of the internal voice line.
2) To adjust ringtone volume (with interphone not in conversation): hold
down 1 of the 2 push-buttons "D" for at least 2 second, then press the
push-buttons repeatedly to increase or reduce ringtone volume, or mute
the ringtone. The "D" push-buttons adjusts the chime volume also during
the emission of the internal or external or outdoor call tone.
F)
Push-button for auxiliary service, 1st relay of 1st actuator type
69RH.
G) Push-button
: to open the lock and terminate any conversation in
progress.
H) Push-button
: for self-start of the interphone without being called.
6
C
M
I)
Two-channel conversation push-button: after the call and/or
switch-on of the monitor press the pushbutton once to activate the
audio. Pressing it once again the conversation terminates.
The red LED remains lit for the whole conversation dwell.
L)
'Door open' signal: if the green LED lights up, this indicates that
the door is open and if the LED is off, it means all door are closed (the
function is optional according to the type of installation).
M)
'Ringtone mute' LED: if the red LED lights up, this indicates that
the call is disabled (see point "E").
The red LED also remains lit for the entire duration of the conversation,
i.e. while the audio is active.
N) Push-buttons: for sctivation of auxiliary services or intercommunicating
calls (in function of the programming)
N.B. On the back of the interphones 6611/AU and 6711/AU is a RESET
push-button for use during programming. In a table version monitor type
661C/AU the "RESET" push-button is placed under the monitor base.
Connection and connector terminal board
+12, CH) Additional ringtone connection.
1, 2)
BUS line.
FP, M)
Connection for landing call push-button.
B
INSTALLATION 6611/AU
- Install the interphone away from sources of light and heat.
- Flush-mount back box type 6149 in the wall at a height of approximately
D
1.4 m above the ground.
- Connect the terminal block.
- Remove the plastic cross-piece from the back box (see detail 1 in Fig. 2)
- Fix the interphone to the back box with the 4 screws supplied (fig. 2).
H
- Fit the side panels, taking care that the panel with the slot for the mi-
crophone is fitted on the right (fig. 2).
I
Flush-mounted
version
E
Art. 6149
136
139
mm
mm
141mm
59mm 10mm
(microphone)
Part. 1
Fig. 2
Publicidad
