Warranty And Repair; Maintenance; Line Fuse; Power Switch - Hameg Instruments HM8123 Manual De Instrucciones

Warranty and Repair

HAMEG instruments are subjected to a rigorous quality control.
Prior to shipment each instrument will be burnt in for 10 hours.
Intermittent operation will produce nearly all early failures.
After burn in, a fi nal functional and quality test is performed to
check all operating modes and fulfi lment of specifi cations. The
latter is performed with test equipment traceable to national
measurement standards.
Statutory warranty regulations apply in the country where the
HAMEG product was purchased. In case of complaints please
contact the dealer who supplied your HAMEG product.

Maintenance

The instrument does not require any maintenance. Dirt may
be removed by a soft moist cloth, if necessary adding a mild
detergent. (Water and 1 %.) Grease may be removed with ben-
zine (petrol ether). Displays and windows may only be cleaned
with a moist cloth.
Do not use alcohol, solvents or paste. Under no
circumstances should any fl uid be allowed to get
into the instrument. If other cleaning fl uids are
STOP STOP
used damage to the lacquered or plastic surfaces is
possible.

Line fuse

The instrument has 2 internal line fuses: T 0.8 A. In case of a
blown fuse the instrument has to be sent in for repair. A change
of the line fuse by the customer is not permitted.

Power switch

The instrument has a wide range power supply from 105 to 253
V, 50 or 60 Hz ± 10 %. There is hence no line voltage selector.
I m p o r t a n t h i n t s
Subject to change without notice
21