Troubleshooting - Sage Kitchen Wizz BFP820 Guía Rápida

Troubleshooting

PROBLEM
Food is unevenly
processed
Slices are slanted
or uneven
Food falls over
in the feed chute
French fries cutter
Some food remains
on top of the disc
after processing
Motor slows down
when kneading
dough
Dough doesn't
clean inside of the
processing bowl
Dough nub forms on
top of dough blade
and dough does not
become uniformly
kneaded
Dough feels tough
after kneading
Dough is too dry
Dough is too wet
EASY SOLUTION
• Ingredients should be cut evenly into 2.5cm pieces before processing.
• Ingredients should be processed in batches to avoid overloading.
• Place evenly cut food into the feed chute.
• Apply even pressure on the pusher.
• The large feed chute must be packed full for best results. If processing
smaller quantities, place items to the far left in the feed chute, or use
a smaller feed chute, depending on the food size.
• Always clear any blocked potato before processing more potatoes.
• It is normal for small pieces to remain after processing.
• Amount of dough may exceed maximum capacity.
Remove half and process in two batches.
• Dough may be too dry. If motor speeds up, continue processing.
If not, add more water, 1 tablespoon at a time until the motor speeds
up. Process until dough cleans the side of the processing bowl.
• Amount of dough may exceed food processor maximum capacity.
Remove half and process in two batches.
• Dough may be too dry.
• Stop machine, carefully remove dough, divide it into 3 pieces
and redistribute them evenly in the processing bowl.
• Divide dough into 2 or 3 pieces and redistribute evenly in processing bowl.
Process 10 seconds or until uniformly soft and pliable. Allowing dough
to rest allows the gluten strands to relax and become more pliable.
• While machine is running, add water through the small feed chute,
1 tablespoon at a time until dough cleans the inside of the processing bowl.
• While machine is running, add flour through the small feed chute,
1 tablespoon at a time until dough cleans the inside of the processing bowl.
EN
21