Tusa BCJ-5960 Manual De Usuario página 10

CHEST BELT POSITION ADJUSTER (BCJ-9100, 6910)
The position of the BCJ-9100 and 6910 chest belt can be adjusted both up and down.
The product is set in the upper position when it is shipped, as shown (Fig. 54). If the
lower position fits better, remove the end of the belt from the buckle, thread through
the lower hole of the belt holder, and set. If the belt still wraps around the shoulder
part in the same way as it did when in the upper position, it will deform the end of the
shoulder part. To avoid this, be sure to set by directly folding back with the belt holder
as shown
(Fig. 55).
r
Belt Holde
CARE AND MAINTENANCE OF YOUR B.C.J.
With proper care and maintenance, your TUSA B.C.J. should provide years of
trouble-free service.
1. Rinse the B.C.J. thoroughly inside and out with fresh water after every use as
follows.
(a) Fill B.C.J. 's Bladder to approximately 1/4 full with clean, fresh water through
Inflator's mouthpiece. (Manual Infration /Deflation button should be pressed.)
(b) Inflate B.C.J. by mouth and shake to distribute clean water around.
(c ) Remove the Airway system by unscrewing bracket
counter clockwise. (Fig. 56)
(d) Pull the valve assembly away from the nut bracket.
(e) Hold the B.C.J. upside down and allow all water and
air to drain out of the nut bracket opening.
( f ) The Airway system should be cleaned separately
from the B.C.J. With the inflation button depressed,
flush with fresh water through the opening of the shoulder dump (water should
run out through the mouth piece.)
* During this procedure some residual water will remain in the inflation/deflation
head. To drain the water hold the Airway system upside down (Inflator side
up/Exhaust side down) and press the Auto inflation button. Water will then drain
from the inflation plug.
Buckle
(Fig. 54) (Fig. 55)
(Fig. 56)
18
(g) Reinstall the Airway system. (Follow steps (d) & (c) in reverse.)
(h) Rinse the entire B.C.J. by dipping B.C.J. in tub of fresh water or flushing with
hose.
( i ) Dry the B.C.J. in a shaded area out of direct sunlight. (B.C.J. should be
completely dry before storage.)
2. Do not store damp or while folded. Store slightly inflated in cool, dark, dry location.
3. Avoid prolonged exposure to direct sunlight. The sun's ultraviolet rays will shorten
the life of the fabric and especially the Inner Bladder.
4. Never rest sharp or heavy objects on the B.C.J.
After every use:
Rinse inside and out with fresh water and drain. Inflate for storage.
TUSA strongly recommends inspection, overhaul and scheduled parts
replacement at least once a year in order to ensure the optimum functioning of
the BCJ.
19
GB