• If necessary, wash the filter (13) in warm, soapy water as
shown in figure I.
• Make sure that the filter is dry before refitting it to the appliance.
• Refit the pleated filter into the plastic pre-filter.
• Close the transparent door and make sure it clicks into place.
TO REPLACE THE DUST CONTAINER
• With the filters installed slide the container back onto the base and rotate
the handle toward the front of the appliance until an audible click is heard.
Ensure that the container is fully fastened back onto the base.
CLEANING THE DUST CONTAINER (FIG. j - L)
WARNING:
Never use the appliance without the filters.
Optimum dust collection will only be achieved
with clean filters.
CAUTION:
appliance on when dust container is removed.
• Push and hold the release bowl button (5)
on the nozzle.
• Rotate the nozzle toward the bottom of
the appliance as shown in figure j.
• Pull the dust container to the side, and
away from the base of the appliance.
• Pull the door latch (9) and open the
transparent door (8).
• Remove the pre-filter (12) and filter (13)
from the appliance by twisting the filter to
the right and pulling it from the appliance
as shown in figure K.
• Once filters are removed, wipe the dust
container with a damp cloth, or rinse with
warm soapy water as shown in figure L
and allow to dry.
TO REPLACE THE DUST CONTAINER
• With the filters installed, slide the
container back onto the base and
rotate the handle toward the front of the
appliance until an audible click is heard.
Ensure that the container is fully fastened
back onto the base.
REPLACING THE FILTER
The filter should be replaced every
6 to 9 months and whenever worn or
damaged. A replacement filter is available
from your BLACK+DECKER dealer (cat. no. PVF110):
• Remove the old filter as described above.
• Fit the new filter as described above.
MAINTENANCE
Use only mild soap and damp cloth to clean the tool. Never let any liquid get inside the
tool; never immerse the main body of the appliance into a liquid.
IMPORTANT:
To assure product SAFETY and RELIABILITY, repairs, maintenance and
adjustment (other than those listed in this manual) should be performed by authorized service
centers or other qualified service personnel, always using identical replacement parts.
Projectile/Respiratory Hazard:
Do not turn
6
J
K
12
L
10
I
13
13
12