Assembly - Georg Fischer EA11 Manual Instrucciones

Accessories for electrical actuators

10.3 Assembly

7
Fig. 19
 Disconnect the actuator from the supply voltage.
 Take the board out of its packaging and check for damages.
 Screw three spacer bolts 1 into installation domes and tighten by hand.
 Fasten board 3 to the spacer bolts with screws 2 and washers.
 If a reset unit or heating element is present:
Mount the monitoring print to the reset unit or the heating element.
The monitoring print is connected to the same installation domes and directly to
plug X1.
 Plug on BCD switch 4 for the desired function.
 Secure the BCD switch with nipples.
Monitoring print
2
4
3
1
77