Jacuzzi MN35959 Manual De Usuario página 19

Operating Instructions
Continued
Pulsation (with lower fl ap in closed position)
– Press "Pulsation" to activate rhythmical wash for massage effect.
– Press "Pulsation" again to release this function.
Nozzle position (with lower fl ap in closed position)
– Press "Cleansing" or "Bidet." Then press "Nozzle Position" and press the up or down arrow to adjust nozzle
position.
– Nozzle position will default to level 3 after each use.
Economy
– Press Economy to activate the power saving function. The unit goes into economy mode 1 hour after being
used.
– In the economy mode, temperature of water and seat will be kept at 86°F.
– The economy bulb icon will show on the remote control and the power light on the left side of the unit will
be green.
– Maximum power saving is 70%.
– When the unit is occupied during economy mode, the temperature will return to original settings. It goes
back to economy mode again in 1 hour.
– Press "Economy" again to release this function. The power light on the left side of the unit will be red.
Water/Seat temperature adjustment (with lower fl ap in open position)
– Press "Water" or "Seat" buttons to adjust temperatures.
– Four levels: Room temperature (OFF), 93°F (01), 99°F (02), and 104°F (03).
Nozzle cleaning (with lower fl ap in open position)
– Ensure seat sensor is not activated.
– Press "Cleaning" button to clean posterior nozzle manually.
– Press "Cleaning" button again to clean feminine nozzle manually.
– Press "Stop" to return nozzle to stand-by mode.
– Refer to "Maintenance."
Time setting (with lower fl ap in open position)
– Time on the remote control is in 12 hours mode.
– To set the hour, press "Time" once and press
– Press "Time" again to set the minutes
– Time will be re-set (12:00) if batteries are changed.
Main unit panels
– For use if remote control batteries are dead.
– To turn off the unit, press "Power/Bidet."
Side control buttons
– Use side control buttons on unit when remote control is broken or its batteries are dead.
– Press "Cleansing" on right side or "Bidet" on left side to start. Press again to stop. DO NOT use sharp
items to press buttons.
Self cleaning
• Nozzle self cleans before and after each use.
Self-diagnosis system
• This appliance has a self-diagnostic system, LED light on the unit will appear in case of malfunction.
• Unplug and contact service center immediately if malfunctioning.
and/or .
19