Parameter Programming - Erreka NAOS Guía Rápida De Instalación Y Programación

6 Install the central mount (9).
x
Ensure that the
operator is
programmed to
store the type of
transmitter to be
used: fixed code (F),
standard (r) or Press CODE for at least 2 seconds. F, r
personalised (r.) or r. lights up in accordance with the
Roller Code (see type of transmitter to be programmed.
"STEP 6" on

page 12).
Keep SET
pressed
down until
1 appears
Release SET
1
STEP
Store door
open
position
2
STEP
Store door
closed
position
3
STEP
Learn
thrusts
(opening
and closing)
9
x
Radio code programming
The memory can store up to 20 different codes. To completely delete the memory, press CODE
for 5 seconds. All transmitters are deleted.

Programming is only accessible with the door shut-down. It is not accessible
with the door opening, closing or timed to close.

During programming, the operator does not start any operation.
Press SET to save the position
Press SET to save the position
Press SET to open the door
When it has closed,
press SET to save
7 Open the door and install the opening stopper
(10) until it comes up against the carriage (11).
Use two self-drilling, self-tapping screws.
10
P260F
Release CODE and press the button of the transmitter to be
programmed again.
The display flashes and the operator buzzes to confirm programming.

Parameter programming

11
Open the door through to the
opening stopper using |+ / |-
Close the door through to the
closing stopper using |+ / |-
When it stops, press SET to
confirm.
Press SET again to close.
P260G
H260A
M260A1
11