Total Open/Close Programming; Pedestrian Open/Close Programming - Erreka PUMA-I Guía Rápida De Instalación Y Programación

Total opening radio code programming (with RSD receiver only)
1
Connect the power supply and
close the gate with DIP1 in ON
position and keeping ST2 pressed
down.
ST2
4
Press the button of the required channel.
DL2 flashes when programming is complete.
1
Connect the power supply and close
the gate with DIP1 in ON position
and keeping ST2 pressed down.
ST2
3
Press ST1 to start opening.
ST1
6
Press ST1 to start closing.
ST1
9
Place DIP1 and DIP2 in OFF. DL3
remains off.
This is carried out in the same way as total travel
programming, with the following differences:
Z
If a receiver other than RSD is used, see the corresponding instructions.
2
Select the code in the transmitter.
R268A
5
Place DIP1 and DIP4 in OFF.
DL3 remains off.
R268D

Total open/close programming

2
Place the DIPs as shown in the
figure (DIP2=ON, DIP1=ON).
DL3
programming mode enabled.
R268A
4
Press ST1 to start slowdown.
ST1
G268A
7
Press ST1 to start slowdown.
ST1
G268D

Pedestrian open/close programming

R268C
SW1
R268E
lights up to show
G268B
G268E
SW1
R268E
• DIP1 and DIP3 are used instead of DIP1 and DIP2
• ST2 is used instead of ST1
• In step 5, stop the gate with ST2
3
Place the DIPs as shown in the
figure (DIP1=ON, DIP4=ON). DL3
lights up to show programming
mode enabled.
6
Disconnect and reconnect the
electrical power supply.
Pedestrian opening radio
code
Programming is carried out in the
same way, using DIP6 instead of DIP4.
5
Wait for it to come to a stop at the
end of travel.
8
Wait for it to come to a stop at the
end of travel.
SW1
R268B
SW1
G268Z
11