Publicidad
Idiomas disponibles
Idiomas disponibles
1.Pre-Install Start Up
Remove unit from box. Check for any signs of con-
A.
cealed damage, and that all optional equipment has
been provided. Contact Wine Guardian immediately if
components are missing or unit has been damaged in
shipping.
B. Connect thermostat and cable to unit.
C. Plug unit into outlet and turn ON/OFF switch to
"ON." The system will turn on after a 5-minute time
delay and the cold air section will start to deliver cold
air. Contact Wine Guardian if the system fails to turn
on.
2. Installation Location
A. Wine Guardian system must be mounted hori-
zontally on its base as shown and be level to +/-
1/4" (0.6 cm) end to end and 1/8" (0.3 cm) side to
side.
B. Mount unit in a location that is easily accessi-
ble for service and allow at least 3 feet (1 meter) for
clearance on either side of the system for mainte-
nance.
C. Mount the system on the floor on an elevated
platform at least 8" (20 cm) high. Unit can also be ceil-
ing mounted or wall mounted by creating a platform to
support the unit base.
3. Wiring Thermostat
NOTE: Only use wiring provided by Wine Guardi-
an or damage to the unit may occur.
A. Unit is supplied with 50 feet (15 meters) of 6-
wire, cable with RJ14 type connection to the Remote
User Interface controller.
B. Disconnect cable from side of Wine Guardian
unit and the Remote Interface Controller. Route the
cable to the desired mounting location within the wine
cellar.
C. Locate Remote User Interface within the wine
cellar mid-point on a wall in an area with good airflow
and away from any windows or heat sources.
D. Remove back plate of controller and mark
mounting points at desired location.
3
Publicidad
